![](https://everythingask.com/img/question/default.jpg)
How do you change the line on a Homelite trimmer?
You may also be curious about how to fix your Homelite trimmer.
Troubleshooting a 2-Cycle Homelite string trimmer
- The screwdriver can be used to gently remove the rubber spark plug boot from the spark plug.
- Use a toothbrush, gas, or a rag to clean the spark plug.
- Allow the rubber boot and spark plug to hang near a metal point on your engine block.
- If there is no spark, replace the spark plug.
How do you begin a Homelite whipper-snipper?
- If you are starting a cold engine, lay the trimmer flat on the ground.
- Make sure you check the fuel tank to make sure it has gasoline.
- The primer bulb is located at the top right of your trimmer engine. Press it about 10 times.
- The choke lever is located near the primer lamp.
Are Homelite trimmers as good as the ones mentioned above?
The Homelite UT33650 gas trimmer is the cheapest and most basic weed whacker we tested. This trimmer is fine for small yards, but can't handle larger ones. The dual-line head is able to slicing grass and weeds with a 17-inch cutting width.
Why is my trimmer line always breaking?
Line can wear quickly and break easily. To properly control the speed of your cutting head, you should ease off the throttle, especially when cutting on hard surfaces. Old cutting lines can become fragile and break . Replace your broken line if it is older than five years.
How do I replace the line in my Yardworks trimmer?
- Grip the cutter knob and turn it counter-clockwise to remove it. Remove any excess yard debris.
- Remove any excess line still wrapped around the previous spool.
- Insert the spring within the replacement spool.
- Pull the replacement line through the slots of the outer hub.
What is a string trimmer used for?
What is the spark plug gap for a Homelite trimmer?
Who makes Homelite string trimmers?
Type | Public |
---|---|
Parent | Techtronic Industries |
Website | www.homelite.com |
Where is model number on Homelite trimmer?
How do you adjust a Homelite carburetor?
- Place the blower on a flat workbench. Locate the three adjustment screws found on the side of the carburetor, just below the air filter.
- Turn the "L" screw clockwise until the screw seats with the screwdriver.
- Turn the "H" screw clockwise until the screw seats.
- Rev the engine.
95% of readers found this page helpful.
Rate this post by clicking on a star above
Thank you for your vote!