Is there something wrong with my backup camera

Afterwards, you might also wonder, "How do I reset my backup cam?"

If you have a switch at the back of your camera

1. Check that your camera is turned on.
2. Locate a small clip or pin.
3. Place the pin in the factory reset recess above the switch at the back of your camera.
4. Hold the button for 10 seconds. After 10 seconds, the top and middle LED lights will switch off. Then both of them will flash red.

Also, my backup camera keeps going black. Your backup camera may be flashing, or giving off static. This could indicate a fraying cable or a poor connection. Repair any damage and make sure that all cables and connections are properly connected to your backup camera system.

Keep this in mind, how much is it to replace a backup camera?

Ungaro says that a moderately priced camera costs about $150. Installation takes on average two hours and costs $75 an hour. He estimates that the average cost of installing a backup camera and a video monitor can be between $500 and $1900.

Is there a fuse to power the backup camera?

For the location of your fuse box, refer to your owner's manual. It indicates that either the camera, or the monitor fuse are blown. The fuse box is usually located under the steering wheel. The backup camera should function properly once the fuse has been installed and the vehicle is powered on.