How do I reset my Rainbird SST?
How do I reset my Rain Bird SST sprinkler?
How do I delete all programming from my Rain Bird ESP–Me sprinkler system and get it back to factory defaults?
- Select Seasonal Adjust from the menu.
- For at least three seconds, press and hold both the left and right buttons simultaneously. Keep pressing and holding the left and right arrow buttons simultaneously until you see "CLEARED" appear on the screen.
- Reset the dial to AUTO RUN.
Why does my sprinkler system continue to run despite the above? Your sprinkler system may continue to run for one reason: it could be that your valves were opened manually. Locate your valve box(es), and then turn the solenoid(s), clockwise, until it is snug. The solenoid is found on top of the valve. It looks like a cylindrical with two wires sticking out.
You might also ask: How do I reset my irrigation system?"
Resetting a Sprinkler System
- The control dial should be in the "off" position.
- To access clear-memory, press the "next" button.
- Hold the "off" button down until the display stops blinking.
- Move the control dial to "run".
- Hold down both the "minus" and "prog buttons simultaneously.
Why is my Rainbird sprinkler system running twice?
You may have a second time setting that will cause a program to repeat. The Start Times control when your ESP-Me Timer will water. They also control how often your Timer will water. You can set up to six start times per program with the ESP-Me.
How does a sprinkler timer work?
How do you test Rainbird rain sensor?
- Locate the rain sensor for your irrigation system.
- Turn on the time clock for the zone nearest the sensor.
- Press and hold down the button on top of the sensor.
- Release the button and the zone should come back on.
- If the system does not shut off or come back on, check for wiring problems.
How do I reset my Rainbird WiFi?
How do I reset my Rainbird controller password?
What does no AC mean on sprinkler system?
How do you replace a sprinkler solenoid?
- Turn off your water supply to the sprinkler system.
- Turn off your irrigation system at the control panel.
- Slide a soil probe into the ground to locate the failed solenoid and valve assembly.
- Scoop the soil off of the valve box using a shovel.
How does a Rain Bird Rain Sensor work?
How do I reset my hunter sprinkler timer?
- Press and hold down the , and buttons.
- Press and release the RESET button on the right side of the controller.
- Wait 2 seconds and release the , and buttons. The display should now show 12:00am. All the memory has been cleared and the controller may now be reprogrammed.
Why does my sprinkler system run twice?
Why is my sprinkler system not turning off?
How do I reset my orbit timer?
How do you test a hunter sprinkler system?
- Press and hold the PRG button. The station number will be flashing.
- Press the or button to scroll to the station you would like the test program to start with. Use the and buttons to set a run time of up to 15 minutes.
- After a 2 second pause, the test program will begin.
95% of readers found this page helpful.
Rate this post by clicking on a star above
Thank you for your vote!